BMW E91 Manuale Utente Scaricare il pdf (Pagina 46)

If you look carefully, you can see that each pin is labeled, so putting pins into the connector should not be

confusing if you take your time and pay attention. This is a close-up picture of the shell for connector x14272:

The remaining three pins of the harness that goes from the 12-pin connector(x13822) on the back of the CID

go to pins that fit into this JBE connector.

This is where they need to go:

• Connect Pin #1 (RT/GE - Power) from CID (x13822) to Pin 37 of connector x14272 of A4010 (JBE) – in

my case, I hooked to the junction for this pin, as shown above.

• Connect Pin #3 (BR – Ground) from CID (x13822) to Pin 27 of connector x14272 of A4010 (JBE)

• Connect Pin #5 (OR/GR – K-Can H) from CID (x13822) to Pin 11 of connector x14272 of A4010 (JBE)

• Connect Pin #6 (GN – K-Can L) from CID (x13822) to Pin 30 of connector x14272 of A4010 (JBE)

All of the pin sockets (except for #37) should

be empty in this JBE connector – if they are not, make double-

sure you are plugging into the correct socket. Put it all together and this harness is done! I paralleled another

harness and fabric taped & zip-tied this harness to another to make it look neat & like an OEM install.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 57 58

Nessun commento

BMW E91 Manuale Utente Pagina 46